Ballzy

pieces of the puzzle

mids

Mids for Glen's Triumph build that Myles and I made up with double row seal bearings and all stainless hardware. Should last a lifetime without getting loose and sloppy. (cause nobody likes that combination) 100% made in house.

IN STOCK, READY TO SHIP!!

All bells pictured are in stock and can be shipped same day. We ship world wide. Run em on a velocity stack or we can set you up with a backing plate and 4" filter. Backing plates available for S&S E, stock CV and SU carbs. We can also powdercoat and polish any of them. $80 and up!!! Call - 204-726-4641

Dirty Jesus

Cast in brass.

Check out our new Face Book page.

http://www.facebook.com/groups/173461836096686/

New pics going up daily, Tell the world Johnny!!

Candied Bacon Jerky!!!

Heather New strikes again with some outrageous chocolate chip/carmel/BACON cookies AND a bag of candied bacon jerky... Unfuckinreal really!! ...oh and some more killer motorsickle parts too!!

The Hinck

Rippin into a customers 07 Triumph America. Frame and trees by Acme choppers who I can't say enough good things about. Great products and service every time. Shaved, ribbed, cut down and polished sporty forks, 21 spool front, 18 rear with Avons. Narrowed and flat bottomed 1971 Triumph tank. We'll hide all the electrics in the oil bag. Simple spring seat, ribbed fender and struts as well as a sissy bar for trips. Take off sporty rear caliper should work with some hand made mids. High, same side rippled pipes?? Oh and some finned covers by Denver Dan! Should be a super fun bike that'll be tearing up the streets of Calgary this summer...probably be faster than Tex's bike...